Generac Error Code 2800 [Fix 2024]

Generac Error Code 2800 – Are you looking for a solution on how to fix Generac error 2800? Don’t worry, you’re at the right place! In this article, I’ll show you an easy way on how to get rid of this error code 2800.

Generac is a backup power generation product for light commercial, residential and industrial markets. Its power system range in output from 800 watts to 9 megawatts. Just like any other product, it also causes few errors and error code 2800 is one of them.

Generac Error Code 2800 [How to Fix]

We can say that if any part of the series circuit is broken or damaged, whether by a switch or loose wire or some other issue, there is a possibility that the 2800 alarm fault will show up for the Auxiliary Shutdown.

You can easily fix the Generac error code 2800 by following the below solution:

Generac has two Auxiliary shutoff switches. Both of these have to be on for your generator to operate. If either or both are turned off, the unit will show the alarm Generac error code 2800.

One switch is located on the back of the generator, it’s a little toggle switch which you have to click on. If you open up the lid of the generator on the right side of the engine compartment, there is another toggle switch. These switches are for Auxiliary shut-offs for emergency. So, make sure that both the switches are ON.

Conclusion: I hope the above article has helped you to fix the Generac error code 2800.

FAQs